The quality of peeling is related to the quality. Therefore, many users are concerned about the reason of poor peeling. What are the specific reasons? Let's follow the manufacturer of the bearing seat of the rotary cutting machine.

The first reason is that the peeling is not good due to the improper single roll. In the face of this phenomenon, the machine should be shut down in time.

The second reason is that the CNC box is not good at peeling due to long-term aging, so it needs to be replaced in time. In addition, if the CNC box is not adjusted well, this problem will occur, so it needs to be checked carefully before use.

It can be seen from the above sharing of the bearing pedestal manufacturers of the rotary cutting machine that the factors causing the bad peeling are closely related to the CNC box, so it is necessary to check in advance when using it